![]() ![]() This product is flammable avoid heat, flame, or smoking during and immediately following application of the foam. Throw away any of the unused medicine that was dispensed out of the can. Patients should wash their hands after application unless the foam is being used to treat the hands. Repeat until the affected areas are treated. If applying to the scalp, move the hair away from the affected area so that the foam can be applied directly to the affected areas. Using your fingertips, gently massage a thin layer of foam into affected areas until the foam disappears. If the can seems warm or the foam seems runny, run the can under cold water. Be sure to dry them thoroughly before handling the foam. If your fingers are warm, rinse them in cold water first. Dispensing directly onto hands is not recommended, as the foam will begin to melt immediately upon contact with warm skin. The amount should be no more than 1 and a half capfuls (approximately the size of a golf ball). ![]() Invert the can and push the button to dispense a small amount of foam into the cap of the can, or directly on the affected skin area, taking care to avoid contact with the eyes. Prior to first application, break the tiny plastic piece at the base of the can's rim by gently pushing back (away from the piece) on the nozzle. Apply sparingly in a thin film to the affected areas of the scalp rub in gently and completely. ![]() Use gloves if required by universal precautions. ![]()
0 Comments
Leave a Reply. |